Compare the variant 401.99002
The round shape of the housing does not identify the calibration. Please select the code, range and analog output of your unit.
Electronic pressure switch Beretta Exclusive Mix 26 · Huba Control 401.99002
Pressure switch Electronic Reconditioned Huba Control 401.99002, cataloged for Beretta Exclusive Mix 26. The label identifies 12 V DC power supply, 0 a range 3 mbar and analog 0,3 a 4,3 V output. Check the full code and connections of your Sensor.
Shipping €9Mainland Spain · free from €120
Returns14 days from receipt
WarrantyView terms
Secure paymentCard · PayPal · Google Pay · Bizum
VAT included
Out of stockAlternative consultations
41 €
Electronic measurement of differential Pressure
The Huba 401 family uses an analog signal to transmit the difference of Pressure. This variant, 401.99002, carries its own output and power values: keeping that data allows you to choose the Sensor for full identification and not just for exterior appearance.
The measurement range is 0 a 3 mbar. The 25 mbar impreso limit in the housing is a different magnitude and should not be used as a switching tarado.
Spare part data
- Manufacturer of the componente
- Huba Control
- Full label code
- 401.99002
- Technology
- Pressure Differential Electronic Transmitter
- Nominal feed
- 12 V CC
- Feed accepted on the label
- 10,4–18 V CC
- Measure range indicated
- 0–3 mbar
- Analogue output indicated
- 0,3–4,3 V
- Maximum indicated Pressure
- 25 mbar
- Ports identified
- P1 y P2
Transcribed data from the printed unit label. They are not measured values in an operating test.
Comparison
Place your part beside it.
Choose a photo of your part to view it beside this unit. Compare the labels, connectors and mounting points from the same angle.
Your photo stays on your device: it is not sent or stored.
Catalogued application and selection
The catalog identifies Beretta Exclusive Mix 26 as the source application. To confirm the purchase, check the Sensor 401.99002 with the cutting of your variant. Membership in the Exclusive family is not enough to choose the Sensor: you must also match the code and the electrical values.
No models are documented for that search.
Compare the Part label installed and the cutting of your variant before you buy.
Before replacing the part
Check P1, P2 and Connector
Ports bears P1 and P2 identification. The technician must keep the Connection provided by the equipment manufacturer and verify the electric Connector.
The installation and testing of the equipment are carried out by a qualified technician.
Service in Madrid and surrounding areas
Do you need us to install it?
We repair boilers in Madrid and the surrounding areas. Installation is arranged separately from the purchase of the part.
Questions about this spare part
Does any Huba Control 401 serve?
No. The complete 401.99002 code, measurement range and output signal distinguish this variant. A similar housing does not confirm that they are interchangeable.
Is it a componente of 230 V?
The label on this Sensor indicates nominal 12 V CC and a 10,4 a 18 V CC interval. It should not be confused with the general power supply of the Boiler.
